| 44cup.com Forums http://forum.44cup.com/ |
|
| hot exhaust http://forum.44cup.com/viewtopic.php?f=2&t=431 |
Page 1 of 1 |
| Author: | nosubt2 [ Mon Jul 19, 2010 2:53 pm ] |
| Post subject: | hot exhaust |
Followed advise here on the forum on building new exhaust. built out of 2.5 inch mild steel pipe with the ball flange suggested by Greg F Problem is the shifter is very VERY hot to the touch. The new ball flange is located below the shifter. I thought it might be leaking. It was not leaking. Anyone have this problem?? Do I need to wrap the exhaust or install a barrier type mat in the tunnel? |
|
| Author: | SteveR [ Mon Jul 19, 2010 3:15 pm ] |
| Post subject: | Re: hot exhaust |
Can't comment on the ball flange, but with my standard three bolt manifold connection, after a race-distance drive, my aluminum shift lever with aluminum knob is normally too hot to touch without gloves. Steve |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|