as approved
| Attachments: |
|
image001MA21908432-0003.jpg [ 20.83 KiB | Viewed 4638 times ] |
| 44cup.com Forums http://forum.44cup.com/ |
|
| floorboard reinforcement http://forum.44cup.com/viewtopic.php?f=2&t=670 |
Page 1 of 1 |
| Author: | joecycles [ Mon Jan 31, 2011 2:26 pm ] |
| Post subject: | floorboard reinforcement |
Does anyone know or remember who was producing the reinforcement bar that welds into the drivers floor board of 944's? thanks joey Sullivan #29 944 |
|
| Author: | JohnB [ Mon Jan 31, 2011 2:51 pm ] |
| Post subject: | Re: floorboard reinforcement |
Don't recall a reinforcement. Going forward I know several, including myself, no longer using the floor to mount seats. Instead adding doubler plates to the sill and center and then rectangular cross section 1/8" wall tubing between. Essentially building a mini cage just above but independent of the floor. |
|
| Author: | joecycles [ Mon Jan 31, 2011 3:07 pm ] |
| Post subject: | Re: floorboard reinforcement |
We are hoping to put the seat lower in the car by installing some plates in the front and rear mounting positions. The front stock mounting point is fairly flimsy and has started to crack in a few places so I feel it needs to go! It is too bad these cars don't fix themselves! Your thought is essentially what I was looking for on this topic. I remember someone sold a kit at one time. Thanks Joey Sullivan #29 |
|
| Author: | Racrdave52 [ Mon Jan 31, 2011 3:50 pm ] |
| Post subject: | Re: floorboard reinforcement |
I remember the post and the picture on the old website don't recall if it was available from anyone though. |
|
| Author: | cris.brady [ Mon Jan 31, 2011 4:30 pm ] |
| Post subject: | Re: floorboard reinforcement |
Wasn't it Ernie at Mantisport? |
|
| Author: | Chris924s [ Mon Jan 31, 2011 4:40 pm ] |
| Post subject: | Re: floorboard reinforcement |
The reinforcement that you guys are thinking of from the old forums was not for the seat. It was simply a reinforcement in front of the seat at the a pillar to help in case of a t-bone accident. It runs from the a pillar to the tunnel. I don't recall anyone selling them just that it was an approved modification. |
|
| Author: | Director [ Mon Jan 31, 2011 7:10 pm ] | ||
| Post subject: | Re: floorboard reinforcement | ||
as approved
|
|||
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|