| Author |
Message |
|
Director
Moderator
Joined: Nov 05, 2009
Posts: 1634
Location: Isle of Palms, SC
|
Point of clarification on the 924S model and fender flares for Stock classification. Fender flares added to the 924S model for the Cup class need to be no wider then stock fenders for a 944 model.
The intention of allowing fender flares for the 924S model is to allow that model to be on equal footing as the 944 model in terms of track width and tire size.
_________________Dave Derecola National Director 944 Cup cup944@aol.com
|
| Mon Dec 07, 2009 10:50 am |
|
|
|
tim pruitt
Driver
Joined: Nov 22, 2009
Posts: 184
Location: Lawrenceville, GA
|
The 924/924S can use the GT Racing 924 GT REAR FENDER FLARES, p/n 261?
These are the famous flares that were used by the factory to convert the 924 into the 924 Carrera GT.
_________________Tim Pruitt88' 924S Wide Body 
|
| Tue Dec 08, 2009 6:42 pm |
|
|
|
Director
Moderator
Joined: Nov 05, 2009
Posts: 1634
Location: Isle of Palms, SC
|
tim pruitt wrote: The 924/924S can use the GT Racing 924 GT REAR FENDER FLARES, p/n 261?
These are the famous flares that were used by the factory to convert the 924 into the 924 Carrera GT. Do they extend the fender width beyond that of a 944? _________________Dave Derecola National Director 944 Cup cup944@aol.com
|
| Wed Dec 09, 2009 12:42 am |
|
|
|
Joeboy
Rookie Driver
Joined: Dec 07, 2009
Posts: 29
Location: Hendersonville, NC
|
Tim, How bout these??? Attachment:
MagnumFenderTrim1.jpg [ 46.4 KiB | Viewed 3514 times ]
_________________
Eurotechnik/Spoiled Boys Racing #72
2011 Cup National Champion
2010 Cup 2nd Place, Southeast Champion
2009 Cup 2nd Place
2008 Supercup National Champion
|
| Wed Dec 09, 2009 8:10 am |
|
|
|
tim pruitt
Driver
Joined: Nov 22, 2009
Posts: 184
Location: Lawrenceville, GA
|
Dave, I do not know. Most all 924S cars use these GT Racing Fender flares.
Joe Boy, That's what I'm talking about....a little bling with the fender flare kit from AutoZone.
_________________Tim Pruitt88' 924S Wide Body
|
| Wed Dec 09, 2009 4:00 pm |
|
|
|
Chris924s
Rookie Driver
Joined: Dec 10, 2009
Posts: 32
|
Tim the flares on my car are the ones that you are talking about. I measured the difference before I cut the sheet metal and it was one inch wider than stock. So the same width as a 944.
|
| Thu Dec 10, 2009 2:50 pm |
|
|
|
Director
Moderator
Joined: Nov 05, 2009
Posts: 1634
Location: Isle of Palms, SC
|
Thanks Chris for the info. We set as stated then.
And if two inches total, thats what we should set the limit for Prepared.
_________________Dave Derecola National Director 944 Cup cup944@aol.com
|
| Fri Dec 11, 2009 10:45 am |
|
|
